Blasting Equipment

PanBlast™ The AIN-6 9.5mm (3/8) Water Induction Nozzle features the ability to slurry wet blast

PanBlast™ The ATN Tungsten Carbide Nozzle is a wide throat, long venturi designed blast nozzle 

Blades that are installed in the blast wheel disk

Wear resistant nozzle to be used with softer abrasives that is part of the Aluminium Handle Set 

Control cage is installed in the blast wheel and determines the throwing angle of the abrasive.

Control cage is installed in the blast wheel and determines the throwing angle of the abrasive.

Blast Wheel Disk that is used to hold the blades

The UBV-7 incorporates additional venturi air inlets for a blast pattern approximately 35% wider than conventional single venturi nozzles, with no increase in compressed air consumption.

The guide is required to fix the impeller into the blast wheel and to give an indication of the installation angle.

Required to hold the blade lock plates in position

Required to fix the impeller to the drive shaft of the blast wheel.

The holder is required to fix the impeller into the blast wheel.