Blasting Equipment

PanBlast™ The Stem Type Pop Up Valve features a durable vulcanized rubber mushroom head and steel stem that is suited for larger capacity pots

PanBlast™ The Pop Up Valve Seating Ring is a heavy-duty rubber O-ring that seats within the pressure blast pot

PanBlast™ The Nylon Hose Coupling is manufactured from tough injection molded nylon composite

PanBlast™ Rubber Nozzle Holder Gaskets to suit nylon blast hose nozzle holders

PanBlast™ The AIN-6 9.5mm (3/8) Water Induction Nozzle features the ability to slurry wet blast

PanBlast™ The ATN Tungsten Carbide Nozzle is a wide throat, long venturi designed blast nozzle 

The UBV-7 incorporates additional venturi air inlets for a blast pattern approximately 35% wider than conventional single venturi nozzles, with no increase in compressed air consumption.

Wear resistant nozzle to be used with softer abrasives that is part of the Aluminium Handle Set 

Wear resistant Rubber hose for to be used for abrasive

Automatic dosing for ultimate additive.

Black wear restistant rubber sheet for internal wear protection in blasting machine

Black wear restistant rubber sheet for internal wear protection in blasting machine.

Red wear restistant rubber sheet for sealing elements (door, roof slot etc.) of blasting machine

Red wear resistant rubber sheet for sealing elements (door, roof slot etc.) of blasting machine

Required to fix the impeller to the drive shaft of the blast wheel.

Blast Wheel Disk that is used to hold the blades

Blades that are installed in the blast wheel disk

Required to hold the blade lock plates in position

Control cage is installed in the blast wheel and determines the throwing angle of the abrasive.

Required to install the holder and control cage together.

The holder is required to fix the impeller into the blast wheel.

The guide is required to fix the impeller into the blast wheel and to give an indication of the installation angle.

Control cage is installed in the blast wheel and determines the throwing angle of the abrasive.

Pins that are required to fix the blades in position

Required to install the holder and control cage together.

Required to fix the impeller to the drive shaft of the blast wheel.